How to Cut Angles with a Laminate Floor Cutter?

12th August 2021


	How to cut angles with a laminate floor cutter?


	Shop for Laminate Floor Cutters


			Before starting to cut laminate it is best to know what you are doing so that you don’t waste any material. Read our step by step guide to making an angled cut on laminate.

			Step 1 – Stabilise cutter Make sure the laminate floor cutter is placed on a sturdy surface.

			Step 2 – Measure and mark Measure and mark the piece of laminate to be cut.

			If necessary, remove the board stopper from the laminate floor cutter.

			Step 3 – Set angle lock Set the angle lock to the desired angle. To do this, loosen the screw and rotate the dial until the arrow points to the desired angle, then tighten the screw again.

			Step 4 – Insert laminate Lift the blade and place the laminate, finished side up.

			Step 5 – Align laminate Align the marking on the board with the edge of the blade. It is important that you have the side to be used on the outside of the blade, and he sliver the blade removes must be taken into consideration.

			Place the trestle under the board if needed.

			Step 6 – Begin cut Lower the blade, using both hands.